sync | Power | Data Comm | STALO | PD & BTH |
---|---|---|---|---|
What is A9
The Spectrum Analyzer receives its display RF from the
|
What is 4A2A16
The Analog Receiver Data Comm series regulator receives its Aux input from which analog cabinet bulk power supply
|
What is 4A2A19A16 CPM/Mux
This circuit card assembly develops a 625 KHz clock from a 10 MHz clock
|
What is C-7-1 + 90 MHz
The output of the Transmit VCO cavity #2 is
|
What is 132
Within the Analog cabinet, PD target returns are attenuated by ____ dB during transmit periods
|
What is BTH Expulse
The analog receivers send signal(s) _________ to the STALO
|
What is none
The BTH Dispersive Delay Line heaters receive their input voltage from which series regulator?
|
What is Once every slant
How often does the RDP receive response data from the Synchronizer
|
What is Fo+60.003MHz
If the RDP commands the clutter VCXO to adjust to 20.001MHz, then the 1st LO frequency would be equal to
|
What is Delta AGC amplifier
What circuit compensates for variations in transmit pulse widths
|
What is RIAU
BTH Target Data is sent to the ________ from the analog receivers
|
What is Manually via 4A2A15S2, S3, & S4
How are the redundant Synchronizer series regulators 4A2A1, A3, & A4 put online
|
What is 4A2A19A15 Comparator.
The 4A2A19A17 Data Control receives the MECL to TTL –5 VDC reference voltage from
|
What is Spectrum Generator 4A2A19A19
Which unit is responsible for creating our 10 MHz, 30 MHz, 60 MHz, 90 MHz, and 120 MHz reference frequencies
|
What is opening target
What is a negative Fd PD target
|
What is
Signal RF INHIBIT is sent to the analog cabinet from which unit
|
What is It is monitored via RIAU STALO DCOM failure messages
How is the 4A2A20 series regulator monitored
|
What is 30 MHz from the STALO
The Synchronizer generates Data Comm Pre-Trigger from which signal
|
What is It modulates the frequency of the RF excitation (F0) with one of the 64 waveforms from the Waveform Generator
What is the purpose of the Single Side-Band Modulator
|
What is To receive 120 MHz 2nd LO in BTH IF #1, 90 MHz 3rd LO into BTH IF #2 and route these
signals into all three BTH IF’s
What is the purpose of the BTH IF Z1 power splitter
|
What is 4A2A19A9
The antenna receives test targets from which unit
|
What is A combination of airflow and air temperature.
What do the CEMs 4A2A30 and 4A2A31 monitor
|
What is To prevent spurious KPA, driver, and L-gate pulses
Why are synchronizer control word 0 and 1 sent twice when changing from a PD Off mode to a PD active mode
|
What is It is only used by tests 23, 24 and System FIT
when is RF sample from the transmitters
|
What is 8 bit target data
How many bits are in a BTH Target
|