Fall Protection | Operation/Traversing/Loading | Overhead Protection | Stability in the Work-Zone | General |
---|---|---|---|---|
What is access gates or openings
These must always be closed prior to the start of the lift
|
What are load capacity limits
Do not exceed ________ When considering number of employees and materials that will be used in the lift
|
What is Clearance!
Always be sure of ample overhead ______ when operating an aerial man-lift
|
What are outriggers
Always ensure these are set on pads or on a level, solid surface.
|
What is prior to each work shift?
A pre-start inspection is required this often
|
What is the floor of the lift platform
Always stand firmly here when operating an aerial man-lift
|
What is the combined weight of the workers, tools, and materials
Always take ________ into consideration when calculating the load
|
What are hazards (power-lines, for example)
Do not position aerial lifts between overhead ______ when possible
|
What are brakes
Always set these when outriggers are used
|
What is (any hazard): falling from the platform, electric lines, drop-offs, unstable surfaces, debris or floor obstructions, etc.
This is one example of a hazard associated with aerial man-lifts
|
What is guard rails or handrails
Do not climb or lean over these when working from the lift
|
What is fall protection
Unless this is immediately available, do not use a lift to access an upper landing
|
What is 10
Always make sure that lifts are _____ feet away from overhead power-lines
|
What are wheel chocks
Always use these when parked on, or working from a sloped surface
|
What is to keep from getting thrown out of the platform, or falling out of the platform
This is why it is important to remain 100% tied while working from an aerial man-lift
|
What is a Rescue Plan
Always make sure this plan is in place when working from an aerial man-lift (fall protection...)
|
What is False
True/False: It is okay to use an aerial man-lift as a crane
|
What is shut down (de-energized) or insulated.
Powerlines need to be either ____ or _____ for work closer than 10 ft.
|
What are cones, caution tape, warning worker above signs, ground level safety monitor, etc.
When working in an area with pedestrians, use these to reduce the likely-hood of someone walking beneath the lift.
|
What is familiarization
The first step to working with aerial man-lifts is the _____ process
|
What are adjacent structures or poles
Do not belt off to these while working from the platform
|
What are lower level controls
Do not operate ______ unless permission is obtained from the workers in the lift platform
|
What is a hard hat
When working below someone, or a hazard above, it is a good idea to wear this when working in an aerial man-lift
|
What is Housekeeping
Picking up trash, clearing debris, organizing tools, materials and equipment are all examples of this
|
What is trained and authorized
Only ___________ and ___________ employer designated personnel may operate man-lifts
|