What two components together make up a manual transaxle?

True or False:
You should remove gears from the mainshaft by heating them with a torch.

When the slave cylinder and throw-out bearing are combined into a single (annular) assembly, a clutch fork is not needed.

True or False:
When installing the transmission after clutch replacement, use the bell housing or transmission case attaching bolts to draw in a binding transmission input shaft.

Gear clash in only one gear during shifting is usually caused by a worn _________.

The component that allows a vehicle's front wheels to revolve at different speeds while turning corners is called the ________ _________.

When helical gears are used, there must be a way of controlling gear _______.

True or False:
Clutch drag can cause gear clashing.

True or False:
The throw-out bearing can be installed after the transmission has been installed.

Technician A says that a gear ratio of 0.7:1 is a reduction ratio. Technician B says that a gear ratio of 3:1 is a reduction ratio. Who is right?

The component that transmits power from the transmission to the rear axle assembly is called the _______ _______.

Technician A says most typed of grease are interchangeable. Technician B says any grease can be used on any type of greaseable component. Who is right?

True or False:
The clutch must be removed to repair the clutch linkage

Technician A says the outer sleeve of a synchronizer assembly does not rotate until it engages the blocking ring. Technician B says that shift forks move the outer sleeve while permitting sleeve rotation. Who is right?

A reassembled transaxle has improper endplay. Technician A says that the endplay is measured with a dial indicator. Technician B says that the endplay can be adjusted by using different selective thickness shims. Who is right?

True or False:
Transaxles used on front-wheel drive vehicles with a longitudinal engine do not use a ring and pinion.

True or False:
Using a gasket where none is required could change endplay adjustments or affect the preload on tapered roller bearings.

Clutch pedal free play should be checked by pushing the pedal with your _______.

True or False:
Water in the transmission is one of the causes of a no-drive condition of a manual transmission.

True or False:
Transaxle synchronizers bring the driven gear up to half the speed of the drive gear.

The number of teeth on the ring gear compared to the number of teeth on the pinion gear is known as the _____ _____ _______.

When should sealer be used on a threaded fastener?

True or False:
A pawl-and-quadrant assembly is a component of a hydraulic clutch release system.

A manual transmission shifts hard in all gears. Technician A says that worn or mis-adjusted shift linkage could be the cause. Technician B says that worn or mis-adjusted clutch linkage could be the cause. Who is right?

A manual transaxle is locked in two gears. Engaging the clutch with the engine running will cause the engine to _______.