Fuel, oxidizer, heat, and self-sustained chemical reaction?

The 5 "S"s of checking wildland tools

The oak harbor conversation club

A rapid ,thorough search done to locate victims as soon as possible.

Referred to as sexless couplings and are connected with one third of a turn.

The maximum heat that can be produced if all the combustibles in an area burn.

Non-Steel toed boots, nomex pants & jacket, web gear and fire shelter are part of which equipment?

Lucky farmers

Immediately activate the PASS device.

A feature on screw thread couplings where the beginning of the thread is cut to provide a positive connection.

These three products of combustion( carbon dioxide, carbon monoxide, and hydrogen cyanide) are considered what?

The three factors that affect wildland fires.

150 North lake winds Pkwy

Providing additional support to key places between a vehicle and the ground to prevent further movement.

Used to stop the flow of water to allow replacement of a burst section of hose or add more sections.

This construction type has exterior walls and structural features made of non-combustible materials or limited combustible materials. Interior construction consists of wood beams for walls and other materials for flooring and wall insulation.

On relatively small fires or deceptively quite areas. In relatively light fuels, grass, herbs, light brush. When unsuspected shift in wind direction or in wind speed. When fire responds to topographic conditions and runs up hill. These are what?

900 SR 19

Using a spring-loaded center punch or striking with a sharp point at the lower corner.

The type of load that is the easiest to load for large diameter hose and most prevalent on our trucks.

Cracks or separation in walls-ceilings-floors-roof, loose bricks or stones falling of coming of the building, and deteriorated mortar between masonry are indications of what hazard?

When 70% or greater canopy coverage and 20mph winds or greater indicate what type hazard?

240 west water street

The pattern of collapse when outer walls remain standing and the floors or roof fail in the middle leaving voids on both sides of the collapse.

Used to achieve maximum water surface for heat absorption and is composed of very fine water droplets.